We came up with a workaround for our hot tinted window problems that we hope will work. Mark found silvered foam core board. After constructing a cardboard template, we cut it to fit the bottom of each of the side rear windows and covered it with silver tape. Will have to wait to see if it works. The third of six window coverings is also done so now we have 3 magnetic curtains for the doors. The mattress pump is now secured under the platform with zip ties and the cross beam that will secure the underbed cabinet has been installed. The cooler arrived yesterday and it's great. It will also serve as a seat for dining once I make a cushion for the top. So. it's off to the store again tomorrow to buy foam.
3 Comments
Ben
2/20/2020 07:27:49 pm
Your platform bed looks rad! Can I find your steps on how you built it? Would love to recreate this for my Sprinter! Thanks-
Reply
Christina Ponce
6/1/2020 12:53:41 am
I'd love the steps on how this was built. Do you have plans you could share? It looks awesome!
Reply
karen
6/1/2020 01:53:58 pm
I used a student drawing program that i know longer have. If you email me at [email protected]. I can send you the PDF I have but it's not wht final version
Reply
Leave a Reply. |
AuthorWe're a Connecticut couple that retired early so we can see our kids, grandkids and the world. We purchased a 2015 144" High Roof Sprinter Passenger Van and we're converting it ourselves into a camper. Archives
June 2016
Categories
All
|